In this last project, I took a plastic Wheelr High School water bottle and drew it in Inventor. The drawings I had to make with it followed the sameoutline as the Bottle Opener, but some parts presented a challenge. I couldn't remove the tip of the lid, so I had to measure around the lid base to measure it. Also, the lid and its features were new and irregular to me. The bottle, though it's the largest part, was probably the easiest.
 |
| Bottle Base |
 |
| Bottle Exploded Isometric |
 |
| Bottle Lid Tip |
 |
| Bottle Section |
 |
| Bottle Lid |
 |
| Inventor Studio Bottle |
No comments:
Post a Comment